What a perc test measures
The University of Minnesota's Onsite Sewage Treatment Program says the percolation test is only a small part of a complete site evaluation. Fixr says a licensed contractor, excavator or professional inspector digs or drills at least one hole, pours in water and watches how fast the soil absorbs it.
The University of Minnesota says to use at least two test holes, and preferably three, when the soil is uniform. Each hole is round, 6 to 8 inches wide, and its bottom must sit at least 3 feet above seasonally saturated soil or bedrock.
Readings come the day after the hole is filled, except in sandy soils. A tester measures the drop in water level about every 30 minutes, until three readings in a row vary by no more than 10 percent. Minutes per inch is the result. The University of Minnesota says not to run the test where the soil is frozen below the depth of the planned system.
Who does it
Fixr says to contact the local or county health or environmental agency. The agency tells you whether a government agent must run the test or whether you can hire an independent engineer, and it may require an official to be present.
In North Carolina, NC State Extension says state law requires a comprehensive soil and site evaluation by the local health department, and an improvement permit before construction begins. Penn State Extension says the local sewage enforcement officer handles permitting and oversees installation of new systems.
What it costs
The two sources differ. This Old House says a percolation test typically costs $700 to $2,000, depending on property size and soil conditions. Fixr says $600 to $800 with an average of $725 for one or two holes deeper than 2 feet, and says it can run from $150 for shallow hand-dug holes up to $2,000. Fixr's page is from January 2025.
In the same 2025 page, Fixr adds that labor averages $100 to $250 per hour, or a flat fee of $300 or more, and that a land survey, if needed, costs about $600.
| Source and year | Price | Source |
|---|---|---|
| This Old House, 2026 | $700 to $2,000 | This Old House |
| Fixr, 2025 | $600 to $800, average $725 | Fixr |
Cost by land size
Fixr says land size influences the number of holes and the cost.
What a pass or a fail means
Penn State Extension says that in Pennsylvania an in-ground gravity absorption area can go on soil with a percolation rate between 6 and 60 minutes per inch and a slope of 25 percent or less. Slower or faster soil needs a more complex system, such as an elevated sand mound, and Penn State Extension says at-grade systems are another option.
Fixr gives 5 to 60 minutes per inch as the range that allows a conventional leach field. It says every city and region sets its own standard, soil can fail by draining too slowly or too fast, and a failed test does not necessarily mean the soil is unusable.
Fixr lists these next steps after a failed test.
- Test another part of the property, where the soil differs.
- Dig deeper to get below the frost line, if the test failed in winter.
- Retest in another season, because the water table changes through the year.
- Ask about an alternative system, such as a mound system.
Test before you buy land
This Old House says land must pass the percolation test before a septic tank can go on it, and recommends ordering the test before buying any land meant for a home. NC State Extension says to find out which type of system works on the soils, and to apply to the local health department for an improvement permit, before you buy a lot. It also says systems built on unsuitable soils usually malfunction by leaking raw sewage to the surface or by contaminating groundwater.
Questions owners ask
- What is a perc test?
- A percolation test measures how fast soil absorbs water. This Old House says it shows how quickly water drains through the soil, which helps design a septic system that disperses wastewater safely.
- How much does a perc test cost?
- This Old House puts it at $700 to $2,000 in 2026. Fixr puts it at $600 to $800 in a page updated January 2025.
- Who can do a perc test?
- Fixr says the local or county health or environmental agency tells you whether a government agent must run it or an independent engineer may.
- What if the land fails a perc test?
- Fixr says a failed test does not necessarily mean the soil is unusable, and lists a test in another area, a retest in another season and an alternative system as next steps.
Sources
- This Old House, How Much Does a Septic Tank Installation Cost?, by Alexis Carthan (updated March 12, 2026), read 2026-11-07
- Fixr, Perc Test Cost, by Adam Graham (updated January 31, 2025), read 2026-11-09
- University of Minnesota Onsite Sewage Treatment Program, Soils and septics (the page shows no date; read November 9, 2026), read 2026-11-09
- NC State Extension, Investigate Before You Invest (reviewed April 23, 2025), read 2026-11-09
- Penn State Extension, Wastewater Management Private Septic Systems (the page shows no date; read November 9, 2026), read 2026-11-09